E.B Granite ltd

Template and Installation Guidelines

We aim to make the templating, delivery and fitting of Granite work surfaces as pleasurable as possible with the least amount of inconvenience.  The following is given for information and indicates the steps and actions necessary to facilitate the above.

Information Required
 

A detailed plan of the worktop area, indicating colour, sink & hob cut-outs, drainers, edge profiles, square returns, tap holes, notches around pipe boxes and any other relevant information.  We will use this plan for pricing, templating and manufacturing the worktops.

A plan of the kitchen unit layout, indicating appliance positions.

Kitchen Installation and Preparation for Templating

The Kitchen Installer must fix all base units and end panels in position.  These must be secured and tied in to the walls, where necessary, before templating.

Any existing/ temporary work surfaces and work surface appliances (i.e. hobs & sinks) must be removed before templating can be carried out.

If walls are tiled, any tiles that prevent the templates being taken, must be removed in order for the new work surfaces to be templated right back to the walls.

All appliances must be on site for templating.

Templating

During templating, a representative must be available to confirm the size and positions of any cut-outs     for hobs/sinks/taps as well as any ambiguous details which need clarification.

Templating may result in changes to the cost of the original estimate if the specification has altered from the original.  E.g. extra cut-outs, increased worktop sizes etc.

Any amendments made to the worktop layout or details will change the cost of the work surfaces and may affect delivery.

Aborted template visits where E.B Granite are not responsible will be charged for.

Fitting New Work Surfaces

This will be approximately 7 working days after templating.

Due to its excessive weight and the fact that in its’ unsupported state, Granite is fragile to handle despite templating it may be necessary to chase out parts of the wall in order to aid the installation. This will need to be made good by others. The work surface installers will not seal where the Granite butts up to the wall.

Aborted installation visits where E.B Granite are not responsible will be charged for.

PRODUCT INFORMATION

The maximum joint free worksurface length is 3000mm.  This can be shorter in some cases dependent on the type and thickness of the product, the size and the number of cut-outs.

Upstands made of a different thickness to the worktop will not necessarily colour match.

Proposed site joints will be marked on your drawing sent back with your quotation.  These may alter subsequent to our template visit and you will be informed accordingly.

Granite is a natural material and is subject to variations in colour, markings and texture.  Claims cannot be accepted based on these variations.

Samples of Granite are to be considered as general guidelines only, and do not bind the supplier on grain size, uniformity, colour or veining of the material.  

The thickness of Granite is nominal and can vary in any one piece.  Plus or minus 2mm per 20mm over the nominal thickness is acceptable.

Many Granites are treated with resin to a greater or lesser extent depending on the Granite type.  However, there will always be pitting to the surface of the material to varying degrees.

Granite worktops for use in kitchens have been sealed to protect against most normal everyday stains.  However, spillage’s such as wine, vinegar, oils and acidic substances should be wiped clean immediately to prevent staining.